MC433G GStep V1.78 Release Notes
April 3, 2009

1.  Version 1.78 adds a number of new features which are summarized below:

      - I2C communications support implemented
      - External I2C devices support:  DRO, SmartLCD, Smart Joystick
      - G Code commands can be stored in onchip EEPROM
      - Limit switch detection enabled/disabled
      - Individual configuration control of each motor
      - New status commands
      - Automatic home position find command
     
2.  EEPROM storage of G Code commands:

    Entering the "/b" commands causes all following commands to be 
    stored in EEPROM. Up to 1900 characters can be stored.  Entering
    "/h" stops recording.  "/r" executes the stored command.

3.  New documentation in preparation

4.  Motor control software version 0.97 is included.  A script file is 
    provided that programs all four motor controllers.